Contact Us

C o n t a c t U s

Use of Quarry Dust to Replace Sand in Concrete An

2021-6-4  strength of concrete when replacing sand by quarry dust from 0% to 100% in steps of 10%. M20 and M25 grades of concrete were taken for study keeping a constant slump of 60mm. The compressive strength of concrete cubes at the age of 7 and 28 days were obtained at room temperature. Also the temperature

Partial Replacement of Sand by Quarry Dust in Concrete

2021-6-4  investigated the partial replacement of sand with quarry dust. Initially cement concrete cube was studied with various proportions of cement concrete + quarry dust (M 20, AND M25). The experimental results showed that the addition of quarry dust as fine aggregate ratio of 30%, 40% and 50% was found to enhance the compressive properties.

An Innovative Method of Replacing River Sand by Quarry

2016-9-9  quarry dust. as . replacement . for sand . has been su. p. por. t-ed in the pr. e. vious study (Manassa, 2010) [5] showing that up to 20% of sand has been effectively replaced by quarry dust in traditional concrete. Ilangovan et al. (2008) [9] reported that the strength of quarry rock dust concrete was comparably 10-12% more than that of

Introduction to Quarry-Dust as Partial Replacement

2020-5-19  Using of waste to make concrete is a new technique to handle waste material from industries. Quarry dust is a waste from the crushing unit which accounts 25%-30% of the final product from stone crushing unit and a reason tocause environmental pollution. Quarry dust can be used as an admixture in concrete efficiently to lessen its impact on environment and human. It can also be used as partial replacement of cement in concrete. Cement can be replaced partially by quarry dust in percentage by weight like 10%,15%,20%,25%,30%,35%,40% and 50%. Experimental Study has shown the effect on Compressive strength of concrete by replacing cement with 10%,20% and 30% of quarry dust

“REPLACEMENT OF SAND BY QUARRY DUST IN CONCRETE”

2021-5-13  addition of granite dust as replacement of natural sand may be due to the filling effect of granite dust due to its high fineness as compared to natural sand. Ganesha Mogaveera. G. Sarangapani and Anand V. R. [2011] [3] have studied the effect of Partial Replacement of Sand by Quarry dust in Plain Cement Concrete for different mix proportions.

Introduction to Quarry-Dust as Partial Replacement

2020-5-19  Quarry dust can be used as an admixture in concrete efficiently to lessen its impact on environment and human. It can also be used as partial replacement of cement in concrete. Cement can be replaced partially by quarry dust in percentage by weight like

PARTIAL REPLACEMENT OF SAND BY QUARRY DUST IN

2017-5-27  concrete before and after setting on each % replacement of sand by quarry dust in M20 and M25 grade of concrete. And to find out if Quarry dust is a suitable replacement of sand or not. From this experimental result it is obtained that the 40% of sand replaced by quarry dust in concrete

Partial Replacement of Sand by Quarry Dust in Concrete

With the specific Another alternative is by using quarry waste to replace the gravity of each constituent known, its weight can be converted use of natural sand.

USE OF QUARRY DUST IN CONCRETE AS REPLACEMENT

2018-10-3  construction work. Quarry dust is produced from crusher unit and each crusher unit is produced nearly 22% to 27% of dust. This dust is completely waste material for crusher unit but quarry dust is useful for construction work as sand. If we mix quarry dust in sand then only 65% to 75% of sand replaced by quarry dust because strength of concrete is

Studies on Quarry Dust as Partial Replacement of Fine

2017-4-30  1. Quarry dust can be used as a finer material which can reduce the voids in concrete. 2. Up to 20% replacement of fine aggregates by quarry dust, the results obtained are satisfactory. 3. From the above results 15% replacement of quarry dust gives high Compressive and Flexural Strength. 4. By using quarry dust wastes instead of conventional

“REPLACEMENT OF SAND BY QUARRY DUST IN CONCRETE”

2021-5-13  addition of granite dust as replacement of natural sand may be due to the filling effect of granite dust due to its high fineness as compared to natural sand. Ganesha Mogaveera. G. Sarangapani and Anand V. R. [2011] [3] have studied the effect of Partial Replacement of Sand by Quarry dust in Plain Cement Concrete for different mix proportions.

Partial Replacement of Sand by Quarry Dust in Concrete

2021-6-4  investigated the partial replacement of sand with quarry dust. Initially cement concrete cube was studied with various proportions of cement concrete + quarry dust (M 20, AND M25). The experimental results showed that the addition of quarry dust as fine aggregate ratio of 30%, 40% and 50% was found to enhance the compressive properties.

Partial Replacement of Sand by Quarry Dust in Concrete

International Journal of Scientific and Research Publications, Volume 5, Issue 7, July 2015 1 ISSN 2250-3153 Partial Replacement of Sand by Quarry Dust in Concrete Sumit L. Chauhan, Raju A.Bondre Assistant Professor P. I. G. C. E. Nagpur Abstract- The paper describe the role of quarry dust In the of various complex silicates are formed, causing the mass to construction of buildings and other

USE OF QUARRY DUST IN CONCRETE AS REPLACEMENT

2018-10-3  construction work. Quarry dust is produced from crusher unit and each crusher unit is produced nearly 22% to 27% of dust. This dust is completely waste material for crusher unit but quarry dust is useful for construction work as sand. If we mix quarry dust in sand then only 65% to 75% of sand replaced by quarry dust because strength of concrete is

Studies on Quarry Dust as Partial Replacement of Fine

2017-4-30  1. Quarry dust can be used as a finer material which can reduce the voids in concrete. 2. Up to 20% replacement of fine aggregates by quarry dust, the results obtained are satisfactory. 3. From the above results 15% replacement of quarry dust gives high Compressive and Flexural Strength. 4. By using quarry dust wastes instead of conventional

An Experimental Investigation on Properties of

The replacement percentages of Cement with GGBS are 20 %, 40 % and 60 % by weight and 25 %, 50 %, 75 % and 100 % of Quarry Dust are used as a replacement of Natural Sand. Various combination of GGBS and Quarry Dust were prepared using M30 Grade of Concrete.

Partial Replacement of Sand with Quarry Dust in

Corpus ID: 212579661. Partial Replacement of Sand with Quarry Dust in Concrete @inproceedings{Sukesh2013PartialRO, title={Partial Replacement of Sand with Quarry Dust in Concrete}, author={Chandana Sukesh and K. B. Krishna and P. S. Teja and S. K. Rao}, year={2013} }

Suitability of Quarry Dust as a Partial Replacement of

To overcome this problem, present study is focused on the suitability to utilize the quarry dust in Self Compacting Concrete (SCC) partially as fine aggregate with the natural fine aggregates. In this work, quarry dust is used as replacement of sand in a different level (0%, 15%, 30%, 45% and 60%) for producing the SCC.

PARTIAL REPLACEMENT OF CEMENT BY QUARRY DUST

2019-4-21  observed that by 25% of partial replacement of cement with quarry dust improved hardened concrete properties. Keywords: Quarry dust, cement, water, aggregates. -----***-----1. INTRODUCTION Quarry dust is a waste product obtained from quarrying. It can be used as an effective filler material instead of cement.

SOIL STABILIZATION USING LIME AND QUARRY DUST

2018-1-27  Since quarry dust is a waste material from quarries and shows pozzolanic characteristics, it is always encouraged to use quarry dust for stabilization where easily and economically available. Quarry dust is extracted from the quarries is a non-plastic fine silt. Its composition varies according to blasting done in quarries.

Partial Replacement of Sand with Quarry Dust in

Corpus ID: 212579661. Partial Replacement of Sand with Quarry Dust in Concrete @inproceedings{Sukesh2013PartialRO, title={Partial Replacement of Sand with Quarry Dust in Concrete}, author={Chandana Sukesh and K. B. Krishna and P. S. Teja and S. K. Rao}, year={2013} }

Replacement of sand by quarry dust in concrete

Replacement of sand by quarry dust in concrete Products. As a leading global manufacturer of crushing, grinding and mining equipments, we offer advanced, reasonable solutions for any size-reduction requirements including, Replacement of sand by quarry dust in concrete, quarry

PARTIAL REPLACEMENT OF CEMENT BY QUARRY DUST

2019-4-21  observed that by 25% of partial replacement of cement with quarry dust improved hardened concrete properties. Keywords: Quarry dust, cement, water, aggregates. -----***-----1. INTRODUCTION Quarry dust is a waste product obtained from quarrying. It can be used as an effective filler material instead of cement.

EXPERIMENTAL STUDY ON REPLACEMENT OF FINE

2015-4-21  110 Int. J. Struct. & Civil Engg. Res. 2014 Kumar S et al., 2014 EXPERIMENTAL STUDY ON REPLACEMENT OF FINE AGGREGATE BY QUARRY DUST IN CONCRETE Vijay P Gowda1, Dinesh1, Kiran muchandi1, Avinash1 and Kumar S1* The reduction in the sources of natural sand and the requirement for reduction in the cost of

Studies on Quarry Dust as Partial Replacement of Fine

2017-4-30  1. Quarry dust can be used as a finer material which can reduce the voids in concrete. 2. Up to 20% replacement of fine aggregates by quarry dust, the results obtained are satisfactory. 3. From the above results 15% replacement of quarry dust gives high Compressive and Flexural Strength. 4. By using quarry dust wastes instead of conventional

Suitability of Quarry Dust as a Partial Replacement of

To overcome this problem, present study is focused on the suitability to utilize the quarry dust in Self Compacting Concrete (SCC) partially as fine aggregate with the natural fine aggregates. In this work, quarry dust is used as replacement of sand in a different level (0%, 15%, 30%, 45% and 60%) for producing the SCC.

SOIL STABILIZATION USING LIME AND QUARRY DUST

2018-1-27  Since quarry dust is a waste material from quarries and shows pozzolanic characteristics, it is always encouraged to use quarry dust for stabilization where easily and economically available. Quarry dust is extracted from the quarries is a non-plastic fine silt. Its composition varies according to blasting done in quarries.

Deformation Behaviour of Erodible Soil Stabilized with

2019-8-1  erodible soil-quarry dust composite at a proportion of 50% quarry dust and 10% cement. It discusses The quarry dust is a good replacement to weak soil or a good additive to help improved a problematic soil. From analysis, the soil strength lies below the To model the surface load of the decorativestreet light and casted concrete wall,

An Experimental Investigation on Properties of Concrete

2020-4-26  with the Control Concrete. It is observed that the optimum replacement percentages of GGBS and Quarry Dust are 40% and 50% respectively. Keywords: GGBS, Quarry Dust, Partial Replacement, Compressive Strength 1. Introduction Concrete is the most widely used construction material all over the World. The constituents of Concrete are Cement,

Stabilization of soil by using solid waste A Review

2017-10-13  construction of structures. Hence in order to improve the properties of such soils many methods are available like soil stabilization, soil replacement, moisture control, prewetting etc. In recent years, soil stabilization by using various minerals like quarry dust, saw dust, copper dust and fly ash were most commonly used.